Motherboard-level repair work lives and dies on the quality of the blade you're holding, and the 2UUL SEXY Full Set exists because a single blade profile never covers every job on the bench. This 16-piece pack bundles all four SEXY series models — S, E, X, and Y — together in one order, so instead of buying each variant separately you get the complete lineup ready for whatever glue, chip, or IC problem lands in front of you. The set ships without handle, which keeps the cost down for shops that already run a 2UUL handle from an earlier purchase or that mount blades in their own preferred holder, making this pack a practical refill rather than a starter kit. Every blade in the set goes through 2UUL's hand-finish process, where a technician with over a decade of hands-on repair experience manually polishes the edge instead of relying purely on machine grinding. That manual pass is what gives the blade its smooth, sharp bite while also making repeat grinding and re-sharpening easier down the line, so the blade holds usable life well beyond a single job. The double-sided uniform trimming technique, protected under 2UUL's own utility model patent, keeps the cutting force even across the blade rather than concentrated at one point, which matters when you're working millimeters away from a BGA chip or a fragile trace. Structurally, the blade tapers from thin to thick along its profile, with the tip running around 0.06mm and the tail thickening to roughly 0.3mm, so the working edge stays flexible and elastic enough to flex under the board without snapping, while the body still holds enough rigidity to apply real prying force. A nano-coating finish sits over the alloy body to resist rust and corrosion, which keeps the edge performing consistently even with daily use in a busy workshop. Model by model, each blade earns its place in this full set for a specific repair scenario. Model S is built to separate the CPU and NAND flash cleanly, letting you lift these chips off the board without tearing surrounding pads. Model E handles motherboard IC and CPU glue removal, cutting through hardened adhesive around chips so they release without extra heat or force. Model X works as the general-purpose edge glue removal tool, suited for trimming and cleaning glue residue along component edges and connector housings. Model Y is shaped specifically to cut through underfill black glue on the board without scratching or gouging the motherboard surface underneath, which is often the hardest part of underfill removal to get right. Having all four profiles in one 16-piece pack means you're not stopping mid-repair to search for the right blade shape — you pull the model that matches the job, whether that's prying a stubborn IC, clearing underfill resin, or cleaning glue residue before a reball or reflow. This set fits naturally into CPU reballing prep, NAND flash removal, screen IC replacement, BGA chip rework, and general motherboard cleaning workflows, making it a staple restock item rather than a specialty tool you reach for occasionally. For a shop running through blades across multiple technicians and daily board-level jobs, ordering the full 16-blade set in one go cuts down on repeat small orders and keeps every workstation stocked with the same reliable profile.
