Aojiw P10 Dual Station Hot Air Rework Station 1200W – BGA IC Motherboard Repair Tool

Running a repair bench in Lahore, Karachi, or Islamabad means your hot air station rarely gets a break. Boards come in with dead-after-flash faults, charging issues, or IC-level board damage, and your air gun goes from PMIC reballing to display connector rework to CPU reflow in the same shift. The Aojiw P10 dual station hot air rework station is built around that reality: instead of one gun doing everything, you get two independent 1200W-rated air guns running off the same unit, each with its own temperature and airflow settings.The dual air gun combination is the core of this station. Both guns work at the same time, which means you're not stuck waiting for one board to finish before starting the next. If you run a service center with more than one technician, this setup lets two people work off a single station instead of buying two separate units. If you work solo, you can preheat one board while doing precision IC removal on another, cutting dead time between repairs. For training institutes teaching board-level repair, this dual setup means two students can practice hands-on at once under one machine, which is a real advantage over single-gun stations that force one-at-a-time training. Flexible control is what makes the dual setup actually usable in a real workshop, not just a marketing point. Each channel gets independent adjustment for temperature and air volume, so gun one can run hot and focused for IC removal while gun two runs cooler and wider for pre-heating a board or drying flux. You're not fighting one shared setting across two different jobs. This matters most when you're doing sequential repair steps — board cleaning at lower heat, then component removal at higher heat — without needing to constantly retune a single gun back and forth. The intelligent digital display keeps both channels visible and readable while you work. You get a direct readout instead of guessing where your temperature knob is sitting, which matters when you're doing repeat repairs on the same IC family and need consistent settings every time. For technicians training juniors on the bench, a clear digital readout also makes it easier to teach correct temperature ranges for specific repair tasks instead of relying on feel alone. ESD safety is built into the P10's design, which protects PMICs, RF ICs, audio ICs, and other static-sensitive components during hot air rework. Board-level components are increasingly dense and sensitive, and an ESD-safe station reduces the risk of static damage while you're working close to exposed pads and solder joints — something that matters whether you're doing a straightforward charging IC change or a more delicate CPU reball. The station ships with multiple nozzle sizes, letting you match nozzle footprint to chip size instead of using one nozzle for everything. Smaller ICs need tighter, more focused airflow to avoid disturbing neighboring components, while larger chips like CPUs or larger PMICs need broader coverage for even heat distribution. Having the right nozzle on hand for the job in front of you cuts down on both rework time and risk of collateral damage to nearby components. In day-to-day workshop use, this station fits into the point in your repair workflow where you've already diagnosed the fault — whether it's a dead phone after a bad flash, a charging issue traced to a bad PMIC, a hang-on-logo case linked to eMMC or storage IC failure, or straightforward board cleaning before reballing. From there, the P10 handles the actual hot air work: heating for component removal, controlled reflow for reinstallation, and preheating boards before more delicate operations like CPU or chipset rework. For repair shops running high daily board volume, a dual-gun setup changes throughput in a way a single-gun station can't. You're not queuing every job through one air gun — you're running parallel work, whether that's two technicians, two repair stages, or training and production work happening side by side. Combined with independent per-channel control and a clear digital display, the Aojiw P10 is built for repair operations that have outgrown a single basic hot air gun and need a station that keeps pace with real workshop volume.