Every technician running a QUICK M7 or M9 station eventually hits a job where a straight-down nozzle just cannot reach the target cleanly, and that is exactly where the QUICK M7/M9 Round bent hot air nozzle 10MM earns its place on the bench. Instead of firing hot air vertically, this nozzle is bent at a 45° angle, letting you approach ICs, connectors, and shielded components from the side while keeping your view of the pad unobstructed and your other hand free to hold a probe or pick. That angled reach matters most when a chip sits close to a board edge, next to a tall connector, or beside a heatsink where a standard nozzle would either scorch nearby parts or simply not fit at the correct working distance. The stainless steel body holds up to repeated heat cycles at the temperatures the M7 and M9 push out, resisting warping and pitting far better than the cheap alloy nozzles that ship as filler in generic kits, so it keeps its shape and airflow pattern job after job instead of drifting out of true after a few hundred cycles. At 10mm, the bore sits in the middle of the common nozzle range: wide enough to bring a mid-sized PMIC, audio IC, or multi-pin connector up to reflow temperature evenly across the whole footprint, but still tight enough that you are not blasting heat across half the board and risking damage to nearby SMD passives or plastic connectors. That balance makes it one of the more frequently reached-for sizes on a repair bench that handles a mix of smartphone motherboards, tablets, and general PCB rework rather than one narrow product line. Fitting is straightforward since it is built to the same mounting interface as the stock nozzles on the M7 and M9 handles, so swapping it in takes seconds between jobs rather than requiring any adapter or modification. In day-to-day workshop use, this nozzle earns its keep on jobs like lifting a dead-after-drop PMIC for reballing, pulling a charging IC that has shorted after a liquid exposure, reflowing a loose board-to-board connector causing an intermittent no-power fault, or reworking a shielded RF module where a straight nozzle would hit the can before the air ever reaches the solder joints. Because the airflow comes in at an angle, you also get a clearer line of sight to watch solder reflow in real time, which cuts down on the guesswork that leads to lifted pads or cooked components sitting under a straight nozzle you cannot actually see past. For technicians who run high volumes of board-level repair, having a bent option in the nozzle set alongside a straight 10mm nozzle means fewer boards get set aside as "too tight to work" and fewer components get damaged from forcing a straight approach into an angled space. It is a simple accessory on paper, but on a bench doing daily BGA, PMIC, and connector rework, the difference between a straight and a bent nozzle is often the difference between a clean five-minute job and a board that ends up with lifted traces. The QUICK M7/M9 Round bent hot air nozzle 10MM fills that specific gap in the M7/M9 nozzle lineup without asking you to change your soldering profile or station settings, since it works within the same temperature and airflow ranges the stations are already calibrated for.
