RELIFE 858 Series 45° Elbow Nozzle 8mm – Hot Air Rework Station Nozzle

Every technician who works under a microscope knows the problem with a straight nozzle: it sits right in your line of sight. The RELIFE 858 Series Elbow Nozzle 8mm solves that by bending the airflow at 45°, so you get a clear, unobstructed view of the board while still delivering focused heat to the exact IC or connector you're working on. This nozzle is built from 304 stainless steel, which matters more than it sounds. Hot air rework generates constant heat cycling, and cheaper metals warp or corrode after repeated use. 304 stainless steel resists that heat fatigue and won't corrode from flux residue or cleaning agents, so the nozzle holds its shape and seal over years of daily use on a busy repair bench. The one-piece, plug-and-play design is where this nozzle earns its place in a working technician's toolkit. You don't need an adapter or extra hardware — the nozzle seats directly into the gun barrel and locks with a snug fit that stops air leakage. A loose or leaking nozzle wastes airflow and drops your effective temperature at the tip, which means longer heating times and more thermal stress on the board. This design keeps the seal tight, so the heat goes where you point it. At 8mm, this nozzle sits in the mid-range of the 858 series lineup (4/5/6/8/10/12mm), making it a solid choice for medium-sized ICs, connector removal, and general board-level rework where you need more coverage than a fine-tip nozzle but still want precision over a full-width blast. Compatibility runs wide across the 858 and 850 nozzle-fit family of hot air stations, including 2008D+, 8586D+, 858D+, 881D, 856AD, 861X, 705, 857DW+, 706W+, 8786D+, 859D+, 850A, 850A+, and 850D. If your workshop runs any of these guns, this nozzle drops straight in without modification. In real workshop use, this nozzle covers the jobs that come up constantly: removing power ICs and charging ICs stuck on the board after a charging issue complaint, reflowing camera and audio ICs, lifting shielded modules for board cleaning, and prepping pads for reballing after an IC change. The 45° bend also helps when you're working close to the edge of a board or near a connector, where a straight nozzle would force you to tilt the gun and lose accuracy. Because it's a direct-fit replacement nozzle and not a full rework station, you don't need to worry about voltage, wattage, or control settings — this is purely an airflow-shaping accessory that inherits its performance from the station it's mounted on. That keeps the part simple, but it also means the quality of the metal and the seal is everything, and that's exactly where RELIFE has focused this design. For a Pakistani repair shop running multiple boards a day — dead phone diagnostics, hang on logo cases, board-level rework — having a full 4mm to 12mm nozzle set on hand means you're never stuck improvising with the wrong tip size. The 8mm size specifically covers a wide range of everyday IC and connector removal work, making it one of the more frequently used sizes in a technician's nozzle kit.