PCB repair work piles up small delays that
nobody accounts for until the day's almost done. You apply glue or conformal
coating after fixing a hardware fault, then sit there waiting for it to cure.
You solder a jumper or change an IC, and the fumes hang around your workspace
until they clear on their own. The RELIFE RL-014E exists to cut both of those
waits down, combining UV curing, smoke exhaust, and cooling into a single
handheld tool you keep within reach during rework.
The UV curing side uses dual high-quality
lamp beads built into the unit, so once you've applied glue, coating, or
adhesive on a repaired board, you point the fan at it and let the curing happen
in minutes instead of leaving it exposed on the bench. RELIFE built in a tilt
switch as a protection design specifically so the UV light doesn't fire
directly at your eyes while you're holding or positioning the fan — a detail
that matters when you're running curing jobs repeatedly through a workday.
Smoke exhaust is the second function, and
it's the one most technicians reach for during actual soldering work. After
jumper lagana or IC change karna on a motherboard, flux smoke builds up fast in
a closed workshop. Switch the RL-014E to exhaust mode and it pulls that smoke
away from your direct work area, keeping your view of the board clear and
cutting down on the fumes you're breathing while working close to a hot iron or
hot air station.
Cooling rounds out the third function —
useful right after hot air rework, where a freshly reflowed board needs to come
down in temperature before you move it or test it. Instead of waiting on
ambient cooling or risking handling a board that's still hot, you point the
RL-014E at it and speed that step up.
All three functions run through a 3-speed
adjustment, so you're not locked into one airflow setting regardless of the
job. Light curing work needs less air movement than clearing heavy soldering
smoke, and the speed control lets you dial that in rather than overpowering a
delicate curing job or underpowering a smoke-heavy one. One-button shutdown
means you're not hunting for a power switch mid-repair when you need the fan
off fast.
Build-wise, this is a lightweight, portable
unit running on a built-in battery with Type-C charging, so it sits on your
bench without a power cord pulling at it, and you top up the battery the same
way you charge your phone or other USB-C tools. Rated at 6W peak power across
its combined functions, it's sized for bench-level repair work rather than
industrial extraction, which keeps it practical for a busy technician's station
rather than a separate ventilation system.
For a Pakistani repair shop running daily
PCB-level jobs — board cleaning, IC reballing, jumper work, glue curing after
motherboard repair — this fan replaces what would otherwise be three separate
tools sitting around your soldering station. It pairs naturally with your hot
air station and microscope setup, stepping in right after rework to handle
curing, smoke clearing, or cooling before the board moves to its next stage of
testing.
