Relife RL-113 5-inch Precision Diagonal Cutter

Every repair bench needs a cutter that survives daily use without losing its edge, and the RELIFE RL-113 delivers exactly that. You reach for a diagonal cutter dozens of times a day on a busy repair bench — trimming a stray wire, snipping a component lead flush to the board, or cutting away a nylon cable tie during a teardown. The RL-113 handles all of it with a jaw built from high-strength manganese alloy steel, heat-treated through a vacuum mesh process and finished with black anti-rust coating. That treatment hardens the cutting head so it holds a sharp edge through repeated use instead of dulling after a few weeks on the bench. The cutting edge itself goes through a high-temperature quenching process, which gives you a flat, sharp bite on wires and leads. When you cut, the line breaks clean instead of dragging or fraying, so you don't waste time cleaning up a rough cut before you continue your rework. This matters most when you're trimming component leads close to a board — a jagged cut risks nicking a neighboring trace or pad, while a clean shear from the RL-113 keeps your workspace tidy and your next step easier. Your workflow speed depends on tools that don't fight you, and the return spring design on this cutter is built for exactly that. Open the jaw, make your cut, and it rebounds automatically — no manual reopening between cuts. That one-handed operation matters when your other hand is holding a board steady, a wire in place, or a magnifier over a tricky solder joint. You move through repetitive cutting tasks — stripping insulation, trimming multiple leads, clearing cable ties from a bundle — without breaking rhythm. The handle carries an ergonomic, non-slip design that stays comfortable through long repair queues. At roughly 56 grams and 130 x 50 x 12.5mm, the RL-113 sits light in your hand and tucks easily into a tool roll or drawer alongside your soldering iron, tweezers, and screwdriver set. Its compact size also means better control in tight spaces — inside a phone chassis, near a connector, or around densely packed components on a motherboard. On a Pakistani repair bench, this cutter earns its place across a wide range of jobs. You'll use it during board cleanup after an IC change, when jumper lagana work leaves excess wire that needs trimming flush. You'll reach for it during charging port repair, network issue diagnosis, or any job where flex cables and insulating sleeves need precise trimming without stressing the surrounding components. It also handles the smaller housekeeping tasks other tools can't — cutting nylon cable clips during disassembly, trimming tape residue, or snipping redundant leads after a repair to keep the board clean. Pair the RL-113 with your existing bench setup — a hot air station for rework, a microscope for close inspection, tweezers for component handling — and it becomes part of a complete precision toolkit rather than a standalone accessory. Whether you run a solo repair shop or a full-service center, a dependable diagonal cutter reduces the small delays that add up across a busy day of dead phone diagnosis, board-level repair, and component-level work. Built for accuracy, engineered to last, and sized for real bench work, the RELIFE RL-113 is a straightforward upgrade for any technician still working with a worn-out or generic cutter.