Relife RL Q7 MULTIPORT CHARGER – 80W 6-Port Smart Charging Station with 15W Wireless Charging, 65W PD/PPS and HD Color Screen for Mobile Repair Shops

The Relife RL Q7 MULTIPORT CHARGER turns one wall socket into a six-port charging bench for the phones, tablets, and accessories that pile up on a busy repair counter. After you finish a charging port replacement, a battery swap, or a full software flash, you need a spot where the device charges while you watch what it does, and this station gives you that spot without a tangle of separate adapters. The 1.9-inch HD color screen shows charging status in real time, and the buttons let you cycle through the voltage and current readings for each port, so you confirm a phone's real charging behavior before it leaves your bench. That quick check answers the question every technician hears at the counter: does the phone charge properly, or does the charging issue return an hour later? Four Type-C ports and two USB-A ports share a combined 80W, and an intelligent algorithm splits that power across whatever you plug in. Ports C1 and C3 carry the heaviest load. Each one delivers up to 65W when it runs alone, steps through 5V, 9V, 12V, 15V, and 20V profiles, and supports PPS from 3.3V to 21V at 3A, which matters when you test modern phones and laptops that negotiate variable voltage. USB-A port A2 reaches 20W and supports QC3.0 fast charging for the many Android phones that still rely on that protocol. Ports C4, A5, and C6 each supply up to 2.4A at 5V, which suits earbuds, smartwatches, and power banks that never need a fast profile. A 15W wireless pad on top charges at 3W to 15W, so you can rest a phone, watch, or wireless earbuds on the surface while every cable port stays busy. The unit draws power from AC100-240V at 50-60Hz, so it runs directly on Pakistani mains without a converter. Place it next to your hot air station and soldering station and it slots into the last step of your repair workflow: you rework a charging IC or a charging connector, clean the board, reassemble the phone, and then charge it here to prove the fix. The same station serves the testing stage after reballing, after an eMMC or UFS reprogramming job, and after a software flash that left a dead phone or a hang on logo problem, because the screen shows at a glance whether the battery accepts current. A multimeter and a microscope still handle board-level fault tracing, and this charger does not replace them, but it closes the loop once the board comes alive. Shop owners get a second benefit at the front desk. Instead of hunting for a cable, you keep six customer devices on charge during long jobs such as boot loop issue diagnosis or a slow FRP lock removal session, and you can stage finished phones for pickup with a visible charge status. The intelligent protection system guards against overvoltage, overcurrent, overheating, and short circuits, and the body uses PC+ABS fireproof material that keeps a busy workstation safer. The unit carries 3C certification and weighs about 305g, so it stays put on the bench and still moves easily between the front counter and the repair table. An RGB light effect signals the charging state on the surface, which helps you spot an idle port from across the room. Technicians who currently juggle single-port adapters, USB hubs, and mismatched cables will find this layout easier to manage, and it upgrades a basic multi-USB hub into a smart station with protocol support for PD, PPS, and QC3.0. If you build a bench around ISP pinout tools, eMMC programmers, UFS adapters, test boxes, reballing kits, and PCB holders, this charger completes the setup as the dedicated power point for your finished devices. KB GSM Store supplies the Relife RL Q7 MULTIPORT CHARGER to repair shops, service centers, and technicians across Pakistan who want a reliable charging and testing station that keeps every port busy and every reading visible.