RELIFE ST-20 Anti-Magnetic Precision Tweezers for IC Chip Placement

When you're placing an IC on a board under the microscope, you need a tweezer that won't slip, won't rust after one wash, and won't pick up stray magnetic pull from your soldering iron or PCB holder. The RELIFE ST-20 solves that with a fine, precisely aligned tip designed specifically for chip placement and IC lead work. You get a tool that grips small components and steel mesh in solder with real control, even in tight areas around a crowded board.

Anti-magnetic construction sets the ST-20 apart from generic tweezers you find on a technician's bench. In a workshop where you're switching between magnetic screwdrivers, iron holders, and soldering equipment, a tweezer that resists magnetic interference keeps your chip placement accurate instead of fighting an unwanted pull mid-repair. This matters most during dead phone repairs where a single misaligned IC lead turns a simple fix into a hardware fault you didn't create.

Stainless steel construction gives the ST-20 rust and corrosion resistance you actually need on a repair bench. Rosin flux, isopropyl alcohol, and wash water are part of daily soldering and rework, and tools that corrode after a few cleaning cycles cost you accuracy over time. The ST-20 holds its tip geometry and surface finish through repeated exposure to these chemicals, so the precision you get on day one stays consistent months later.

Grip comfort plays a bigger role in repair work than most technicians expect. The ST-20's ergonomic handle and smooth rounded edges remove the pressure points that come with cheaper tweezers, letting you work through IC removal, reballing, or fine component placement without your hand cramping halfway through a job. A non-slip design keeps the tweezer steady in your fingers even when your hands are damp from flux cleanup or working near a hot air station.

In a typical mobile repair workflow, the ST-20 fits between your hot air station and your microscope station. You use it to lift and place ICs during reballing, position jumper wires on damaged traces, align steel mesh during solder paste work, and handle small connectors and fixtures during board-level diagnostics. It complements soldering irons, hot air rework stations, and PCB holders already on your bench, giving you the fine motor control those larger tools can't provide on their own.

Whether you're clearing a boot loop issue caused by a shifted IC, doing chip-off work for FRP lock removal, or handling delicate flex cable connectors during a display problem repair, the ST-20 gives you the tip precision and chemical resistance to work confidently at board level. It's built for technicians who place chips for a living, not for occasional hobby use.