When you're working on a dead phone or prepping a board for IC change, the tool you pick up first decides how clean the job goes, and the 2UUL DA11 Hand Finish SEXY Blades Set is built exactly for that moment on the repair bench. This 4-in-1 kit pairs a single sandblasted alloy handle with four purpose-built blades, so instead of reaching for a generic scraper and risking a lifted pad, you swap in the blade that actually matches the task in front of you. Model S handles the separation of CPU and NAND flash components, giving you the control you need when lifting tightly packed chips without disturbing neighboring pads. Model E is shaped specifically for motherboard IC and CPU glue removal, cutting through hardened adhesive without dragging across solder mask. Model X takes over edge glue duty, working into tight corners where underfill meets the board edge. Model Y is the one you reach for when cutting black underfill glue, since its profile is designed to slide beneath the epoxy layer and separate it from the board without hurting traces or nearby components. Every blade in the set is hand-finished, not machine-stamped, which is why the edges hold their sharpness through repeated grinding and stay usable long after cheaper blades round off. The alloy construction gives each blade the rigidity to resist flexing under pressure while still holding enough flexibility to follow the contour of a board during underfill cleaning, and that combination is what keeps the blade from digging into copper or chipping a BGA pad mid-job. The handle itself gets the same attention to detail — a sandblasted finish that produces a fine, frosted texture across the alloy surface, so your grip stays steady even during a long session of glue removal or chip lifting. That grip matters more than it sounds on paper; a slick handle is how slips happen on a board you can't afford to damage. This set fits naturally into ISP, eMMC, and UFS repair workflows where you're already working close to the CPU and NAND, since board prep — cleaning old glue, separating a chip, clearing underfill — usually comes before you ever touch a programmer or reballing station. Technicians doing BGA reballing, CPU reflow, or NAND replacement use tools like this to prep the pad area before reballing, and the same blade set handles the cleanup after a board comes off a hot air rework station too. If your workshop deals with hang-on-logo boards, boot loop issues, or dead-after-flash repairs where a board-level fault is suspected, having a dedicated glue and underfill blade set on your bench cuts the guesswork out of chip removal. It's also a natural companion tool alongside your hot air station, microscope, and PCB holder, since underfill and glue removal is a step that happens between diagnosis and the actual chip-level fix. For a repair shop running multiple technicians, having a labeled 4-in-1 set like this on each bench means less time hunting for the right blade and fewer damaged pads from using the wrong edge for the job. The DA11 doesn't try to be a multitool that does everything poorly — each blade has one job, and that focus is what makes it reliable for board-level work where a single slip can turn a simple glue removal into an expensive trace repair.
