When you strip down a phone or tablet for board cleaning, screen separation, battery replacement, or any general disassembly job, the exposed camera lens sits right in the path of dust, flux residue, IPA overspray, and stray debris from your soldering station or hot air rework work. The 2UUL DA30 Camera Lens Protective Sticker exists to solve exactly that problem. Instead of leaving a lens uncovered and risking a scratch or a film of contamination that shows up as a blurry photo after reassembly, you place one of these stickers over the lens opening before you start work and peel it off once the job wraps up. The pack gives you two sizes in one box: 500 pieces at 7mm for smaller front-facing or single rear lenses, and 500 pieces at 12mm for larger rear camera modules and multi-lens arrays common on newer devices. That split covers the vast majority of lens diameters you run into across daily repair intake, whether you're working on an old single-camera handset or a current triple-lens flagship. The adhesive is formulated to hold firmly enough to stay in place through an entire repair session, including hot air rework near the board, but releases cleanly without leaving sticky residue behind on the lens glass or the surrounding housing. That residue-free removal matters more than it sounds like on paper — a lens that comes back gummy after sticker removal means extra cleaning time and a higher chance of leaving streaks that a customer notices immediately. Water resistance and dust resistance are built into the sticker material itself, so it doubles as a barrier during ultrasonic cleaning steps or when a board sits exposed near a cleaning station. Technicians running an IC change, jumper lagana, or any close soldering work near the camera housing use this sticker to stop solder splash, flux fumes, and stray solder balls from settling on the lens surface. The same logic applies during full board cleaning passes with IPA, where uncovered glass picks up streaking that's tedious to polish out later. Because the sticker ships flat and pre-cut, application takes seconds with a pair of tweezers or a spudger, and there's no cutting or trimming needed on the bench. For a shop running high device turnover, the 1000-piece count keeps you stocked for weeks without reordering, and the dual-size layout means you're not stuck buying two separate SKUs to cover both lens categories. This isn't a tool that fixes a fault on its own — it's a workflow protection consumable, the kind of small item that quietly prevents callbacks and redo jobs. If you already stock ISP pinout tools, UFS adapters, or a hot air rework station on your bench, the DA30 pairs naturally into that same repair line, since any job that opens a device for board-level work benefits from having the camera covered before the first screw comes out. Store the pack in a dry drawer away from direct sunlight to keep the adhesive performing consistently across the full 1000-piece count, and treat it as a standard part of your pre-repair checklist rather than an optional extra.
