Kaigexin KGX- TQ5 Non Magnetic Scrapper for Clean Tin and Paste Control.Every technician who has reballed a CPU or eMMC knows how one small mistake in the tin stage ruins the whole job. A sloppy or magnetised scraper drags paste across the stencil, smears it into neighbouring holes, and forces you to clean the board twice. The Kaigexin KGX- TQ5 Non Magnetic Scrapper targets that exact step. Kaigexin builds its KGX tool line for phone repair benches, and this model covers the tin scraping and paste handling side of the work. You keep it in the same tray as your tweezers, flux, and stencils.Why a Non Magnetic Scraper Matters on a Phone Board.Phone boards pack shield cans, tiny passives, and metal dust within a few millimetres of every BGA pad. A magnetic blade attracts that dust, then drops it back onto the pad you just cleaned. A non-magnetic scraper avoids the problem. When you work around a Qualcomm or MediaTek CPU, an eMMC, a UFS chip, or a power IC, you want the blade to push paste and tin, not collect metal shavings. That matters most on a dead phone, a boot loop job, or a phone that went dead after flash, because one stray particle under a reballed chip can bring a second fault. Wipe the blade with isopropyl alcohol between passes so old flux never contaminates fresh paste.How You Use It in Your Repair Workflow.Start with the board secured in a PCB holder under your microscope. Lift the chip with your hot air station, clean the pads with your soldering station and wick, then place the reballing stencil and apply paste. Pull the KGX- TQ5 across the stencil in one steady pass, lift the stencil, and check every hole. Use the same tool to level tin on a pad, scrape away excess, and clear residue before you seat the chip again. Hold the blade at a low angle, keep the pressure light, and avoid dragging it across solder mask. Technicians who run IC change and CPU reball jobs repeat this sequence dozens of times a week, so a tool that handles the tin stage cleanly saves minutes on every board. Pair it with Reballing Kits for stencils and balls, Multimeters for pad continuity checks after cleaning, and Hot Air Stations for the lift and reflow steps..Who Should Add It to the Bench.Repair shop owners, board-level technicians, and service centers across Karachi, Lahore, and Islamabad handle reballing and IC rework every day. A scraper costs far less than a programmer or a rework station, yet it affects the quality of every reball you finish. If you already run Soldering Stations and Microscopes, a dedicated non-magnetic scraper tightens your tin stage. If you work with ISP Pinout Tools, eMMC Programmers, UFS Adapters, or Test Boxes, you still need clean pads before you solder a pinout wire or place a chip. Order the Kaigexin KGX- TQ5 Non Magnetic Scrapper from KB GSM Store and ask our team about matching stencils and flux for your workflow.