Every mobile repair workshop reaches a point where a standard spudger or plastic pry tool just can't cut it — literally. Motherboard sealant, hardened UV glue around ICs, and dried BGA solder paste need something sharper and stiffer than the average opening tool. That's exactly the gap the Kaisi Carbon Sharp Blade #17 fills on your repair bench. This 10-piece set gives you a stock of carbon steel blades cut to the #17 profile, one of several shapes in Kaisi's Carbon Sharp Blade lineup. Where a #16 or #23 blade might suit a different angle of attack on a board, the #17 shape is built for technicians who need a controlled, inclined edge for close-quarter scraping around chips and connectors without slipping onto neighboring components. Built for board-level work, not just phone opening Kaisi manufactures this blade from special carbon steel, then hand-grinds and polishes the cutting edge — a process the brand runs at a finer grade than standard blades sold in generic tool kits. That extra grinding step matters when you're working millimeters away from an IC pad. A dull or overly brittle edge either skids across the board or snaps under pressure. The carbon steel construction here holds toughness even when the blade gets inserted at an angle and flexed during prying, so you're not replacing blades every other repair job. Where this blade earns its place on the bench Pull this blade out any time you're clearing motherboard sealant before a board-level fault check, scraping old solder paste off BGA pads before reballing, or cutting through the sticky IC edge glue that holds shield covers and chips in place. It also works as a general curved pry tool for lifting connectors and separating layered PCB sections during a hardware fault diagnosis. For a workshop handling dead phone boards, boot loop cases, and charging issue repairs on a daily basis, having a fresh set of ten means you're never stuck mid-repair waiting on a single worn blade.Fits your existing repair workflow This blade slots naturally alongside your ISP pinout tools, eMMC programmers, and UFS adapters — most board-level jobs that involve chip removal or reballing start with clearing glue and paste before the actual data work begins. Pair it with your hot air station and reballing kit for IC change work, or keep it next to your microscope station for close visual work on fine pitch components. Technicians running a PCB holder setup will find the #17's inclined design easier to control at a fixed working angle than a straight-edge blade. Why buy the 10-piece pack Buying single blades means constant reordering and downtime when one edge dulls or chips. The 10-piece pack keeps your bench stocked for weeks of daily glue removal and scraping work, and having spares on hand means your technicians aren't sharing or waiting. Each blade comes from the same hand-ground batch, so you get consistent sharpness and profile across the full set — no picking through inconsistent stock. For a service center or repair shop in Pakistan running multiple boards through the workshop each day, this kind of consumable reliability directly affects turnaround time. A technician who isn't hunting for a working blade gets the board back on the bench faster, and that's what the Kaisi Carbon Sharp Blade #17 is built to support.
