The Mechanic iCharge 8C gives your repair bench one charging station for the whole queue of phones, tablets and smartwatches waiting on the shelf. Most workshops lose time juggling single adapters, hunting for free sockets and guessing which phone still pulls current, and this multi-port digital charger removes that mess from your daily workflow. You plug the unit into the wall once, connect your cables to the integrated USB ports and the PD Type-C port, and the independent digital display shows the voltage and current each connected device draws in real time. That live reading matters when you test a handset after a charging port repair, because you see immediately whether the phone accepts current or stalls, long before the customer arrives. A technician who handles charging issue complaints all day knows how often a faulty cable or weak adapter hides the real hardware fault, so a stable multi-port source cuts out one variable before you open the board. The unit supports QC3.0 and PD protocols, which lets compatible phones and tablets negotiate faster charging instead of sitting on slow standard output, and the intelligent trickle mode switches in when a battery fills so the charger stops pushing full current into a finished device. The body measures 95 x 75 x 57 mm, so the charger takes a small footprint beside your hot air station, soldering station and microscope, and the input accepts AC100~240V, which covers the mains supply you run in Pakistani shops and service centers. Think about where the charger fits inside a repair job. After an IC change karna job on a charging circuit, after a battery swap, or after a software marna session on a phone that previously sat dead after flash, you still need to confirm the device charges, holds charge and warms up normally. You can keep this charger next to your multimeter and test box, run a quick current check on the display, and clear the phone for delivery without carrying a separate adapter around the bench. When you repair several devices in a day, you load the phones that passed testing onto the charging ports, keep finished units charged for customer pickup, and free your single-port adapters for the phones still on the diagnosis list. Shop owners with a busy counter can also use it as a customer charging point, so people waiting for a quick display or battery job top up their phones without borrowing your bench power. The charger runs at low temperature without heating up during normal use, which suits the long shifts a busy workshop runs. You can charge a phone, a tablet and a smartwatch at the same time, using whichever cable each one needs, because the ports share a single compact body. For training institutes, the digital display also shows students how voltage and current behave when a phone pulls power, which adds a practical charging-circuit lesson to the work they do under the microscope. If you plan an upgrade path for your bench, you can pair this unit with PCB holders, reballing kits and ISP pinout tools so that testing, repair and charging all stay within reach. Mechanic iCharge 8C does not replace a bench power supply for fault finding on a dead board, so keep a DC power supply for that job and use this charger for post-repair verification and day-to-day charging. Buyers in Pakistan who want a compact, digital, multi-port charger from the Mechanic range for a mobile repair workshop, a service center or a small shop counter will find that the iCharge 8C covers daily charging needs with clear on-screen feedback and QC3.0/PD support. Add it to your bench, keep your sockets free, and spend your time on the repairs that earn money.
