One-Stop OS 2015 WICK (10PCS Each) Desoldering Braid

One-Stop OS 2015 WICK (10PCS Each) is a desoldering wick pack for technicians who remove solder dozens of times a day on the repair bench. A wick works through capillary action: you lay the braid over the unwanted solder, press your hot iron tip on top, and the molten solder flows up into the braided strands instead of staying on the board. That single action handles most small cleanup jobs, from a stubborn solder bridge between two pins to a messy pad after you lift an IC. The pack holds ten pieces, so you never stop work to hunt for a spare when one piece fills up, and you can hand a fresh piece to every technician in your shop. Think about a normal day on a Pakistani workshop table. A dead phone arrives after a failed charging port replacement, and you find a solder bridge across the connector pins that shorts the line. You touch the wick to the bridge, heat it briefly, and the short disappears without lifting the pads. Another phone comes in with a charging issue, and you must clean the old solder off the charging IC footprint before you fit a new chip, so you run the wick across the pads until they sit flat and shiny. After IC change karna on a hardware fault board, leftover solder spoils the next reballing step, and the wick leaves the pads ready for a stencil. You also use it before jumper lagana, because a clean pad takes the jumper wire neatly and holds it firmly. Technique matters as much as the product. Pre-heat the area with a hot air station or a properly set iron, place the wick flat on the solder, and press the tip on top of the braid, not directly on the board. Let the braid take the solder, slide it forward to a clean section, and repeat until the pad looks clean. Cut the used section with side cutters and continue with fresh braid. Never drag a heavily loaded braid across the board, because stuck solder can pull small pads away. Keep your iron temperature under control on lead-free boards and keep each contact short, so you protect nearby small components and the board surface. Store your pieces dry and sealed, away from dust, because dirty braid soaks up solder poorly. You get the best result when you pair the wick with a good soldering station, a hot air station, a microscope for close inspection, and sharp tweezers for placement. After cleaning, check the pads under the microscope for missing pads or damaged tracks, then move on to reballing kits, stencils, or direct IC placement. The One-Stop OS 2015 WICK pack also suits training institutes, because students practice solder removal many times and ten pieces cover a full practice session. Shop owners like it because it keeps consumable cost predictable and keeps every bench stocked. For routine work such as display connector cleanup, battery connector pads, and board cleaning after liquid damage, the wick gives you a quick, low-risk way to remove excess solder. If your shop handles boards daily, check KB GSM Store for matching soldering stations, hot air stations, flux, solder paste, reballing kits, and microscopes, so your whole solder removal setup arrives in one order. Order One-Stop OS 2015 WICK (10PCS Each) from KB GSM Store and keep clean solder removal ready for every phone that lands on your bench.