One Stop OS-K10 Precision Knife – Aluminium Handle with Stainless Steel Blade (5 Pcs)

Precision cutting is one of those workshop
skills that separates a fast technician from a slow one. When you're pulling
adhesive off a motherboard, trimming a flex cable, scraping dried OCA glue from
a frame, or cleaning around a soldering point, a quality precision knife makes
every step cleaner and faster. The One Stop OS-K10 is built exactly for that
kind of work — and it does it consistently across thousands of cuts.

The OS-K10 uses a stainless steel blade
that holds a sharp edge across repeated use. Stainless steel resists corrosion
from flux residue, IPA cleaning solution, and the general moisture present on
any active repair bench. The blade angle suits fine-detail work perfectly —
getting under OCA film, lifting adhesive stickers from PCBs, or scoring glue
lines around back glass without gouging the surface underneath.

The handle deserves equal attention.
Aluminium construction keeps the knife light enough for extended use without
hand fatigue, and the anti-slip grip surface means you stay in control even
when your fingers carry flux or cleaning solution. Every technician knows how
fast a slippery handle causes a slip — the OS-K10 grip design eliminates that
problem directly.

A plastic safety cap ships with every
knife, covering the blade when not in use. On a busy repair bench where
multiple tools share the same workspace, this cap prevents accidental blade
contact when you reach for another tool. It also protects the blade tip from
damage during storage, keeping it sharp for the next job.

This knife set comes in a 5-piece pack,
giving you enough blades and handles to equip multiple technicians in a shared
workshop, keep extras in rotation as blades dull, or distribute across separate
repair stations. Blade replacement is simple — no tools required, just swap
when the cutting edge no longer feels responsive.

In a Pakistani repair workshop context, the
OS-K10 fits directly into the day-to-day flow of hardware fault diagnosis and
component-level repair. When you're doing display problem repair that requires
separating a frame with adhesive buildup, or trimming insulation from jumper
wire during jumper lagana work, a knife this precise cuts the task time down
significantly. It also works well when cleaning around BGA pads before
reballing, removing thermal pads, or trimming kapton tape to size before PCB
rework.

The knife pairs naturally with other bench
tools — use it alongside a PCB holder while doing chip-level soldering, next to
a hot air station during frame separation, or alongside a microscope setup for
fine detail removal work under magnification. For shops already working with
reballing kits, soldering stations, and ISP pinout tools, the OS-K10 fills the
precision hand-tool gap at a working price point.

Simple in design, consistent in performance
— the One Stop OS-K10 is the kind of tool every repair bench needs and often
underestimates until it's actually in hand.