RELIFE HO2 Camera Lens Protection Sticker Set (1000 Pcs) – Green

When you strip a phone down for a motherboard repair, screen replacement, or reballing job, the camera module is one of the most exposed and easily damaged parts on the board. Dust settling into the camera lens or dot matrix during disassembly is a common cause of comeback complaints, especially on jobs involving true depth or Face ID sensors, where a speck of dust can trigger a "Blu-ray face" error or camera detection fault after reassembly. The RELIFE HO2 Camera Protection Sticker Set exists specifically to prevent that problem at the source. Each set gives you 1000 protective stickers split across two sizes: 600 pieces at 7mm and 400 pieces at 12mm. This range covers the common front and rear camera lens diameters found across most modern smartphones, so you're not stuck reaching for the wrong size mid-repair. You apply the sticker directly over the lens or sensor before you start any dust-generating work, whether that's board cleaning, IC reballing, glass separation, or general disassembly, and it stays in place until the job is done. What makes this set genuinely useful on a workshop bench isn't just the coverage, it's the adhesive itself. The stickers use a high-temperature-resistant, non-sticky formulation, which means they hold up fine if the board passes near a hot air station or reflow process without degrading or melting onto the lens. When you're finished and peel the sticker off, it comes away clean, without leaving a gummy residue that would otherwise force you into an extra cleaning step or, worse, risk scratching the lens coating while you scrape residue off. RELIFE also built a small tail into each sticker's design. It sounds minor, but if you've ever tried picking a tiny protective film off a sheet with tweezers under a microscope, you know how much time that costs across a full day of repairs. The tail gives you something to grip directly with your fingers or tweezers, so you can peel, place, and move on without fumbling. On a technician's bench handling several dead phones or board-level jobs in a shift, that small design choice adds up to real time saved.
This set fits naturally into any repair workflow where the camera module is exposed to risk: PCB-level repair and reballing, screen and glass replacement, chip-level Face ID or True Depth sensor work, and general board cleaning where solvents or brushes are in use near the lens. It's a consumable every board-level technician should keep stocked, alongside your soldering consumables and cleaning tools, since a single overlooked speck of dust on the lens can turn a clean repair into a customer complaint about camera or Face ID issues. For repair shops and service centers handling volume work in Lahore, Karachi, or Islamabad, having a dedicated dust barrier for the camera during every teardown reduces avoidable rework and keeps your quality consistent across technicians on the same bench.