Sunshine SS-905H DC Power Supply Cable For Huawei Samsung Xiaomi Android Phone

Sunshine SS-905H Power Cable for High Voltage Android Phone Repair The Sunshine SS-905H DC Power Supply Cable For Huawei Samsung Xiaomi Android Phone gives your repair bench a clip-free way to power a dead phone from a DC bench supply. Many recent Android boards from Samsung, Huawei, Oppo, Vivo, Xiaomi and Meizu need 8V high voltage output on the battery connector, and a plain 4V lead will not wake them. This cable closes that gap. You plug it into the battery connector, set your supply, and watch the phone respond. It works like an experienced technician’s shortcut: no loose crocodile clips, no battery swapping, and no guessing whether the board even draws current.How the SS-905H Fits Your Dead Phone Diagnosis Every hardware fault diagnosis starts with the same question: does the board draw current, and how much? With the SS-905H on your DC supply, you answer that in the first minute. Connect the cable, power the phone, and read the current on your supply display. A phone that draws nothing points you toward the battery connector, a charging IC or a blown fuse line. A phone that pulls high current right away points you toward a short, so you reach for your microscope and hot air station next.This cable also helps once you fix the fault. After an IC change karna job, you power the board through the SS-905H and confirm it boots before you close the phone. If the phone hangs on logo or loops in a boot loop issue after a flash, the live current reading tells you whether the board sits idle, spins up, or stalls. You can also keep the cable attached while you do software marna work, since it holds the phone powered without a battery. That saves time on every dead after flash case that lands on your bench. High Voltage Output, Dual-Cell Support and Protection The SS-905H puts out up to 8V and holds a constant voltage and current, so the board sees a steady feed while you probe it. Front and rear brackets output at the same time, which starts high voltage dual-cell devices immediately. You do not need to move the cable or add a second lead. The cable also accepts new connector types, so it keeps up with newer models as they reach your shop. Protection matters when you work on live boards. The cable carries multi-level overvoltage and overcurrent protection with independent recognition, so one fault does not hide behind another. If a dead short appears, the cable cuts the feed before it damages the board or the supply. You still need to watch your supply and set sensible limits. Treat the cable as a safety net, not a replacement for good bench habits. It also keeps a 1:1 fit between the battery holder and the cable, so the connector sits firmly and does not slip off while you probe or press on the board. Build Quality and Where It Fits Your Bench Technicians bend and plug these cables all day, so the SS-905H uses thin, ultra-flexible custom wire that resists kinks and takes repeated bending and voltage cycling. The cable stays easy to route around a microscope stand and a PCB holder. It pairs well with a hot air station, a soldering station, a multimeter and your ISP pinout tools, because you can switch from power-on testing to rework without changing your setup.If you want a digital display and live current monitoring built into the cable, look at the Sunshine SS-905D or iBoot-D as your upgrade path. Many shop owners still keep the SS-905H on the bench for fast, clip-free high voltage Android work. You can order the Sunshine SS-905H from KB GSM Store and check its price in Pakistan on the product page.