YCS 2IN1 UV Curing Light Lamp With Cooling Fan

Every micro-soldering job leaves two problems on your repair bench: a hot motherboard you cannot touch for minutes, and fresh solder mask that stays soft until UV light hits it. The YCS 2IN1 UV Curing Light Lamp With Cooling Fan handles both jobs from one compact body, so you stop switching between a separate fan and a separate UV torch after every rework. YCS builds this unit around a 3W UV curing lamp and a 1W cooling fan, and one button switches you between curing mode and cooling mode. The design pulls air in from the rear and pushes it out the front, which sends a focused stream onto the board area you just reworked, and YCS rates the cooling response at around three seconds. The same airflow carries solder smoke and flux fumes away from your face while you work under the microscope, which matters in small repair shops where ventilation stays poor and the bench sits close to the customer counter. Think about a typical hardware fault job: you lift a charging IC with the hot air station, clean the pads, place the new chip, and reflow it. The board now holds heat in the shield frame and nearby capacitors, and if you flip it or press on it too early, you risk shifting fresh joints or stressing nearby BGA chips. Point the YCS fan at the board and the temperature drops fast enough that you move straight to testing on the DC power supply instead of waiting. The UV side earns its place on jobs where you repair broken traces, add jumper wires, or rebuild damaged pads. After you route a jumper on a phone that came in with a charging issue or network issue, you coat the wire and exposed copper with UV solder mask, the green oil most technicians keep on the bench. The 3W UV lamp sets that coating quickly, locks the jumper in place, and insulates it from shorts against the shield or neighboring components. The same lamp cures the UV glue technicians use to secure small components and hold a delicate board-level repair in position before reassembly. Build quality suits daily shop use. YCS fits the unit with durable heat-dissipating LED beads, and LED indicator lights show you which mode runs at any moment, so you never guess whether the UV lamp sits on or off. The body measures 60 x 56 x 40 mm and weighs about 104 grams, so it sits beside your PCB holder, soldering station, and microscope stand without eating bench space, and you can hold it at the right angle in one hand while your other hand keeps the board steady in the fixture. In the wider repair workflow, this tool belongs to the post-soldering stage. It follows your hot air station and soldering station work, and it pairs naturally with a quality PCB holder, a stereo microscope, and a reballing kit for CPU and IC jobs. It supports diagnostics too: a cooled board gives you more reliable readings on your multimeter and DC power supply, because heat can hide a short or make a marginal component behave normally for a few minutes. Technicians who handle higher volume and want adjustable fan speeds, stronger airflow, or built-in fume filtration can later step up to a larger multi-function cooling and curing station or a dedicated fume extractor, but for most single-bench shops this 2-in-1 unit covers the daily need at a sensible UV curing lamp price in Pakistan. KB GSM Store supplies this YCS tool to technicians in Lahore, Karachi, Islamabad, and every other city where repair shops need practical tools that save bench time. When your daily work includes jumper repairs, solder mask touch-ups, IC replacements, and quick cool-downs after reflow, one tool that does both jobs keeps your bench cleaner and your turnaround faster. Order the YCS 2IN1 UV Curing Light Lamp With Cooling Fan from KB GSM Store and keep cooling and curing within reach on every repair.