YCS 90 Degree Dot Matrix Positioning For iPhone 13/14 Tweezers

Face ID repair on the iPhone 13 and iPhone 14 series leaves no room for a shaky hand. The dot projector module sits inside the TrueDepth camera assembly, it measures only a few millimeters, and one wrong tilt during positioning can undo an hour of careful work. The YCS 90 Degree Dot Matrix Positioning For iPhone 13/14 Tweezers solve that exact problem. YCS shaped the head at a clean 90-degree angle so you can grip the dot matrix module from above, hold it level, and place it exactly where it needs to sit, without your fingers or the tweezer body blocking your view under the microscope.
Straight and curved tweezers work well for SMD parts, jumper wire, and screws, but they grab a component from the side. A dot matrix module needs a vertical, centered hold. With side-grip tweezers you often push the module off its seat at the last moment, or you press unevenly on the flex and create a fresh fault. The right-angle design of these YCS tweezers lets the tips close around the module while your hand stays out of the work area. You get steadier control, a clearer sight line through the microscope, and fewer repeat attempts on a customer’s phone.
Most Pakistani repair shops see the same pattern on these models. A customer brings in an iPhone 13 or iPhone 14 with a Face ID not available message after a fall, water damage, or a careless back glass or screen job. Once you confirm the dot projector as the hardware fault, the repair moves to the bench. You open the TrueDepth assembly, separate the dot matrix module, and rework the flex or transfer the original component so the phone keeps its paired part. Every one of these steps involves lifting, holding, and positioning the module, and that is where the YCS 90 degree tweezers earn their place.
Pair the tweezers with a dot matrix alignment fixture or Face ID repair clamp. The fixture holds the flex and the assembly in position, and the tweezers handle the module itself as you seat and align it. Under a stereo microscope, the 90-degree head stays below your line of sight, so you watch the edges of the module line up instead of guessing. This combination cuts down rework, and in a busy shop rework is the real cost, not the tool.
YCS gives these tweezers an anti-rust, wear-resistant finish. A repair bench sees flux, IPA, hot air, and constant handling, and rust and worn tips usually end the life of a pair of tweezers. Worn tips lose their grip on small parts, and corrosion on a tip can leave residue on a clean flex. A finish that resists both keeps the tips closing true for longer, which matters on a tool you pick up for every Face ID job.
Keep these tweezers dedicated to Face ID and dot matrix work rather than mixing them into general board repair. Wipe the tips with IPA after each job, store them with the tips protected, and never use them to pry shields or lift hot components, because bent tips lose the precise closing this tool depends on. Treat them this way and they stay accurate through many repairs.
These tweezers fit inside a wider Face ID repair setup. Build your bench around a stereo microscope for visibility, a PCB holder or repair fixture to lock the assembly, a Face ID dot projector tester to confirm the fault before and after the job, and a precision soldering station or hot air station for any flex rework. Our Microscopes, PCB Holders, Soldering Stations, and Hot Air Stations categories cover each of these. When you want to take Face ID work further, the natural upgrade is a dedicated dot projector programmer and tester, which lets you read and write module data instead of only moving hardware.
For Pakistani technicians, Face ID repair on the iPhone 13 and 14 series has become steady paid work, and customers now expect it at the local shop instead of a costly service center. The YCS 90 Degree Dot Matrix Positioning For iPhone 13/14 Tweezers are a small, affordable tool that removes one of the most common failure points in that repair. Order from KB GSM Store and get delivery to your workshop in Lahore, Karachi, Islamabad, or anywhere in Pakistan.