Kaigexin Non-Magnetic Scraper for Clean Board-Level Repair Work.The Kaigexin KGX- TQ1 Non Magnetic Scrapper gives your repair bench a dedicated tool for the unglamorous part of board work: lifting glue, flux crust, and hardened residue before you touch an IC. Every workshop in Lahore, Karachi, and Islamabad knows the problem. You pull a CPU or an eMMC chip, the pads sit under baked-on epoxy and old flux, and the nearest tool is a screwdriver tip or a cutter blade that scratches the solder mask and drags metal bits across the board. This scraper replaces that habit with a purpose-made hand tool, and its non-magnetic build stops ferrous particles from clinging to it while you work.How the Scraper Fits Your Repair Workflow.Board work follows a sequence: diagnose, heat, lift, clean, reball, refit. The KGX- TQ1 earns its place in the clean step. After your hot air station softens the adhesive around a chip, you scrape the residue from the edges and the surrounding area in short, controlled strokes, then move to your soldering station and flux cleanup. You can use it on a dead phone where a previous technician left glue everywhere, on a hang on logo board that needs its memory chip reworked, and on a charging issue board where the connector area needs cleaning before fresh solder goes down. Because you drive the tool by hand, you control the pressure. Keep your strokes light, clamp the board in a PCB holder, and watch the pads under your microscope. The same habit helps on a display problem job: when adhesive hardens around a frame or camera bracket, you scrape it away from the edge inward, brush off the dust, and check the surface before the new part goes in.Why Non-Magnetic Matters on a Phone Motherboard.Phone boards carry tiny metal debris: solder balls, shield slivers, and loose pin fragments. A magnetic tool picks up ferrous bits and drops them back onto pads and connectors. A non-magnetic scraper does not pull those particles toward the edge you are working with. That keeps each cleaning pass predictable, especially near fine-pitch pads where one stray fragment causes a short and sends you back to the multimeter for another round of diagnosis. If you run reballing kits and stencils on your bench, a non-magnetic hand tool also keeps fine metal parts from tugging at your work. Power the board off and pull the battery before you scrape, and treat the tool as conductive, so a slip never touches a live circuit.Where It Sits in Your Tool Kit.The scraper handles the cleaning, and other tools handle the rest of the job. Pair it with hot air stations to soften adhesive, soldering stations for pad work, microscopes for inspection, and multimeters for short checks after cleaning. If your bench handles ISP pinout work on eMMC programmers or UFS adapters, you scrape first so the pads are clean when you probe, and your test box or programmer reads the chip without contact trouble. New shop owners can start with the Kaigexin KGX- TQ1 Non Magnetic Scrapper and add reballing kits and PCB holders as the jobs grow. When you later move up to heavier rework equipment, the scraper stays in your tray, because every board still needs cleaning before and after the main repair. Order from KB GSM Store and get a Kaigexin scraper that fits the way technicians in Pakistan actually work: heat, lift, scrape, clean, and move on to the next board without losing time to messy pads.