Mechanic C210 MIX 3-in-1 Soldering Tip Set (SK/TI/TS) for T210 Handle

Every mobile repair bench eventually needs more than one tip shape, and that's exactly what the Mechanic C210 MIX 3-in-1 Soldering Tip Set solves. Instead of buying separate tips one at a time, you get the SK (Knife), TI (Curved), and TS (Straight) profiles in a single pack, all built for the T210 handle. If you've ever struggled with board cleanup after an IC change or needed a finer tip for a jumper under the microscope, this set covers that range without switching handles.The SK Knife tip is the one you reach for right after removing a chip or IC. Its flat edge is built for cleaning boards and chips after removal, and it handles large solder pads well, making it useful when you're prepping a pad for reballing or clearing old solder off a ground plane. The TI Curved tip is where the precision work happens — it's designed for jumper wires, micro-components, and soldering under a microscope, which matters when you're doing fine jumper karna on a tightly packed motherboard where a straight tip just won't reach the angle you need. The TS Straight tip rounds out the set as your everyday driver, handling connector pins, capacitors, resistors, and diodes — the parts you solder on nearly every board that comes in for a charging issue or a display problem.What makes these tips hold up on a busy bench is the build. Each tip uses a nickel-chrome alloy steel core with a multi-layer electroplating treatment, so they resist corrosion and oxidation far better than uncoated tips that burn out after a few weeks of heavy use. They're built for lead-free soldering, which matters if your shop has moved away from leaded solder for board-level work, and the thermal conductivity is good enough that you're not waiting around between joints. The internal heating design means the heating element sits built directly into the tip rather than as a separate cartridge, so heat transfer and recovery stay efficient even when you're moving quickly between a knife pass and a fine jumper.For a workshop doing mobile board repair, this set fits naturally into your normal flashing and hardware fault workflow. You clean the pad after IC change with the SK, run your jumper lagana work with the TI under the microscope, and finish connector or component work with the TS — all without swapping handles or hunting for the right tip mid-repair. Since all three share the same T210 fitting, they drop straight into your existing soldering station setup.If your shop already runs a Mechanic T210 station, or any T210-compatible handle, this tip set is a straightforward way to keep board cleanup, jumper work, and general component soldering covered from one box, without tying up your budget in three separate purchases.