QUICK M7/M9 Round Bent Hot Air Nozzle 8MM – 45° Stainless Steel Rework Nozzle for BGA & SMD Desoldering

The QUICK M7/M9 Round bent hot air nozzle 8MM solves a problem every bench technician runs into eventually — a straight nozzle that blasts hot air straight down onto a component you can barely see because your hand and the gun body are in the way, and this bent design angles the airflow at 45 degrees so you keep a clear line of sight on the pad while you work; the 8mm round opening spreads heat evenly across mid-size ICs, connectors, and multi-pad components without concentrating too much heat on one corner, which matters when you're pulling a charging IC or a small PMIC off a board without lifting or cracking neighboring pads. Stainless steel construction resists the constant heat cycling that wears out cheaper nozzles within weeks — you get a nozzle that holds its shape and internal diameter through hundreds of rework cycles instead of warping or corroding after a few months of daily use in a busy repair shop. The quick-release fitting on this nozzle matches the mount system built into both the QUICK M7 and QUICK M9 hot air stations, so you pull the old nozzle and click this one into place in seconds, without hunting for tools or fighting a stuck fitting mid-job — that matters when a customer is standing at your counter waiting on a dead phone or a hang on logo fault and every minute counts. On the workbench, this nozzle earns its place in board-level repair, PCB rework, and BGA-adjacent tasks: IC removal around network and power ICs, desoldering charging ports and battery connectors, separating shielded components without disturbing the solder mask around them, and reflow work where you need a tighter, more directional airflow than a straight or square nozzle gives you. Pakistani technicians working on boot loop issue, network issue, and hardware fault cases reach for a bent nozzle exactly for this reason — many of these faults sit on ICs tucked next to taller components, and a straight nozzle either can't reach the angle cleanly or ends up overheating parts you never intended to touch. The 8mm size sits in the middle of the common nozzle range, wide enough to cover multi-leg ICs and small connector blocks in one pass, yet narrow enough that you're not dumping excess heat onto surrounding components on a densely packed board. Within your repair workflow, this nozzle fits between diagnostics and reassembly — once you've traced a fault to a specific IC or connector using your multimeter or a test box, this nozzle becomes the tool that lifts the failed part cleanly so you can jumper lagana or replace it and move the board back into testing. Pairing it with a PCB holder keeps the board steady while you angle the gun, and running it alongside your ISP or eMMC toolkit rounds out a full board-level repair setup rather than leaving you with only straight-nozzle coverage. Because it shares the same mount standard across the M7 and M9 lineup, you're not locked into buying nozzles per machine if your shop runs both stations side by side — one nozzle style covers your whole hot air fleet. Whether you're running a solo repair counter or managing a service center with several benches, this nozzle gives you a dependable, repeatable angle and heat spread for the jobs that a straight tip simply can't reach cleanly.