Sunshine 917C Dustless Worktable for Mobile Repair

Sunshine 917C Dustless Worktable: A Cleaner Bench for Screen and LCD Jobs

Every technician in Pakistan knows the pain. You press a new display, power it on, and a dust speck sits right under the glass. The Sunshine 917C Dustless Worktable attacks that problem at the source. It blows filtered air across the work area, lights the panel clearly, and gives you a padded surface sized for phones and tablets. You do not need a full cleanroom, just a small station that keeps your LCD change and lamination work clean. This page explains how the table works on your repair bench and where it fits next to your other tools.

How the Filter and Airflow Work

The table has a three-layer filter core that traps fine particles, including PM2.5-size dust, before the air reaches your work area. You control the fan through adjustable air volume, so you can run strong airflow while you clean a panel and drop it low when you handle thin film or small parts. Low airflow matters when you place OCA or polarizer, because strong wind can lift loose pieces. Run the fan for a minute before you open a new screen, then keep the glass inside the clean zone until you seal it. Replace the filter core when airflow weakens or the filter looks dirty. Dusty workshops clog filters faster than you expect.

Lighting and Dust Checking

The LED lighting gets a 20 percent brightness increase over the earlier design, and the manufacturer also offers a version with a dust checking lamp. Confirm which version you order. Good light shows lint, fingerprints, and fine scratches on the glass before you laminate, so you fix them early instead of after the glue cures. Pair the worktable with a microscope from our range when you inspect flex connectors, FPC pads, or small damage near the display connector. That way you cover both the surface and the board work.

Working Surface and Where It Fits in Your Workflow

The worktable gives you a 34.5 × 23 cm working size, wide enough for tablets as well as phones. An extra-thick silicone pad protects the panel from scratches, and the bayonet design keeps setup simple. Use it for LCD replacement, screen lamination, display cleaning, and cleanup after glass separation. When a display problem traces back to a connector or IC, move the phone to your PCB holder, hot air station, and soldering station for the hardware fault. Then return to the Sunshine 917C Dustless Worktable for the final screen fitting. If your lamination volume grows, you can add a dedicated laminating setup later, and this table stays useful as the dust-free assembly station beside it.